|
Clock hands (available at most craft stores)
drill with drill bit that drills through tile
Drill a hole in the center of the tile
Vinyl Application Instructions
(For all vinyl lettering projects)
Your quote is made up of three layers. The
top layer is the transparent sticking tape, the actual letters
are the middle layer, and the bottom layer is the stiff backing
paper. All surfaces must be flat, clean and dry before applying.
Step 1: Clean the surface with glass cleaner
and a dry cloth. Dirt and dust particles will cause vinyl
lettering to bubble.
Step 2: Draw horizontal guidelines in the
area you wish to apply your lettering. Take your sheet of words
and flatten the surface out so there is no rolling up.
Step 3: On a flat
surface gently but firmly rub over the words to make sure all
letters have adhered to the sticking tape.
Rub over the top of the sticking tape again, just to make sure
the letters are sticking to it.
Step 4: With the quote
facing up so that you can see it, begin to slowly peel up the
sticking paper, which will grip the letters, and be all in one
piece. The letters should stick to the
sticking tape. If any of the letters aren't
sticking, press them down again with the tape, and rub over them
with the edge of a credit card or application squeegee.
Step 5: Place the taped letters on the
prepared surface, using your guidelines to position them
correctly. Firmly "squeegee" the lettering to force the bubbles
out with your application squeegee or edge of credit card.
Start in the center and work your way out. Be sure you
have gone over all areas.
Step 6: Gently peel off the transfer tape,
leaving the letters in place.
Step 7: You are finished!
|
We
support homemakers and share ideas needed for 
